Parkside PDB 100 A1 Traduction Des Instructions D'origine page 18

GB IE
General description
An illustration of the most im-
portant functional components
can be found on the front and
the back fold-out pages.
Scope of delivery
Carefully remove the device from the pa-
ckaging and check whether all the parts
listed below are present and complete:
• Woodturning Lathe (two-part)
• Face plate
• Tailstock
• Tool table (two-part)
• 2 lathe chisel (1x straight, 1x hollow)
• 2 x open-ended spanners
• Allen key
• Mounting material:
- 6 hexagon bolts, 6 clamping disks,
6 washers, 6 nuts
- 3 screws, 3 clamping disks, 3washers
• Instruction manual
Dispose of the packaging material
properly.
Overview
1 4-edge lathe point
2 Tool table
2.1 Screw, height adjustment
2.2 Bottom part of tool table
3.1 Rail with motor unit
3.2 Rail
4 Locknut
5 Tailstock
6 Handwheel
7 Foot
8 Lever, tailstock
9 Lever, tool table
18
10 On switch
11 Off switch
12 Allen key
13 Face plate
14 Lathe chisel, straight
15 Lathe chisel, hollow
16 Open-ended spanner
17 Screws with clamping disk and
washer
18 Hexagon bolts with clamping
disk, washer and nut
19 Drive shaft
20 Locking screw
21 Gear cover
22 Retaining screw
23 Motor unit
24 Lever, motor unit
25 Drive pulley
26 V-belt
27 Locking switch
Description of functions
The lathe is intended for processing pieces
of wood. The clamped workpieces can be
rotated at three different speeds.
Please refer to the descriptions below for
information on how the operating elements
work.
Technical data
Woodturning Lathe ..... PDB 100 A1
Rated voltage U ................... 230-240 V~
Rated frequency ............................50 Hz
Rated consumption P ................... 400 W
Operating mode ................... S2 15 min*
Idle speed
n ...........890/1260/1760/2600 min
0
Protection class ..................................... I
Protection type .................................IPX0
Spindle head thread ........................ M18
-1