Schmidt SS 30.300 Notice D'utilisation page 95

Setting of the preset counter / the pulse value (ImPS)
The adjustable values (0.003 to 3 000000 Nm
in the program. The display, however, shows a 4-digit detail (the 4
most significant digits) of the set figure.
Display area,
example
1
0 0 0 0 0 0 1
2 0 0 0 0 0 1 2
3
0 0 0 0 1 2 3 .0
4
0 0 0 1 2 3 0
5
0 0 1 2 .3 0 0 0 0 0
6
0 1 2 3 .0 0 0 0 0 0
7 1 0 0 0 .0 0 0
Digits which are not displayed are always set to the value zero. When
changing to the next higher display area, the least significant digit is
shifted to the right out of the display window and set to zero, irre-
spective of its previous value.
Example: Change from display area 3
Setting operation:
1. Make sure that OU1 is set to ImP (→ page 36).
2. Press the "Mode/Enter" pushbutton until ImPS is displayed.
3. Press the "Set" pushbutton and keep it pressed. The current
numerical value flashes for 5 s, then the most significant of the 4
digits becomes active (digit flashes, can be modified)
4. "Set" the requested value as described in the table on the follow-
ing page.
First, select the requested display area (1, 2, 3,...).
Then set the figure from the left (most significant digit) to the right
(least significant digit).
5. Briefly press the "Mode/Enter" pushbutton (acknowledgement)
after having set all 4 digits.
Indication
0.003 ... 9.999
.2 3 0
.3 0 0 10.00 ... 99.99
100.0 ... 999.9
0 0
1 000 ... 9 999
.0 0 0
10.00 ... 99.99
100.0 ... 999.9
0 0 0 1 000 ... 3 000
to display area 4
3
) are given as 10 digits
LED 10³ Value in Nm³
OFF 0.003 ... 9.999
OFF 10 ... 99.99
OFF 100 ... 999.9
OFF 1 000 ... 9 999
ON 10 000 ... 99 990
ON 100 000 ... 999 900
ON 1 000 000 ... 3 000 000
0 0 0 0 9 5 6 .7 0 0
0 0 0 1 0 5 6 .0 0 0
31