Jøtul F 360v2 Advance Manuel D'installation Et D'entretien page 20

ENGLISH
Replacing the burn plates
Fig. 34
A
B
1. Lift the baffl e plate (A) slightly and remove the side burn
plate (B) from the burnchamber. Note! The baffl e plate
keeps the side burn plates in position. Make sure that the
burn plates do not fall down when the baffl e plate is being
liftet.
2. Remove the side burn plate (C) on the other side from the
burnchamber.
20
Fig. 35
3. Remove the burn plate (C) by unscrewing the screw (D) in the
centre. Lift it up and tilt the burn plate out.
Replacing the exhaust defl ectors
Fig. 36
A
C
4. The lower and upper exhaust defl ectors are located above
the baffl e plate. Remove the lower defl ector (E) by lifting it
at the rear edge and tilting it out.
5. Lift the upper defl ector (F) out of the grooves and remove
it from the burn chamber.
When refi tting, follow the same procedure in reverse
order.
C
D
F
E