Publicité
Les langues disponibles
Les langues disponibles
Safety precautions when handling lead
acid batteries
CAUTION! Health hazard
The water-acid liquid inside the battery can
evaporate and cause an acidic odor. Use the
battery only in a well-ventilated area.
NOTICE! Damage hazard
The battery is not sealed. Do not turn the
battery on its side or upside down. Place
the battery on a horizontal surface.
Check the acid level for open lead acid
batteries regularly.
Immediately recharge deeply discharged
lead acid batteries to avoid sulfation.
4 Scope of delivery
Description
Battery charger
Short operating manual
5 Intended use
PLUS25, PLUS30 and PLUS40 only: The battery
charger is used to charge 1 or 2 house batteries. The
battery charger uses DC voltage as a power source and
supplies this to the connected house battery.
GOLD25-M, GOLD30-M and GOLD40-M only: The
battery charger is used to charge 1 or 2 house batteries.
The battery charger uses DC or AC voltage as a power
source. AC is converted to DC voltage. DC is supplied
by the battery charger to the house battery.
The battery charger enables the charging of lead
acid, gel, AGM, and lithium (LiFePO4) batteries with a
capacity of more than 75 Ah.
The charger is intended to be used in campervans and
RVs.
The battery charger is not intended for charging the
starting battery or for operation with a remote control.
This product is only suitable for the intended purpose
and application in accordance with these instructions.
This manual provides information that is necessary for
proper installation and/or operation of the product.
Poor installation and/or improper operation or
maintenance will result in unsatisfactory performance
and a possible failure.
The manufacturer accepts no liability for any injury or
damage to the product resulting from:
• Incorrect installation, assembly or connection,
including excess voltage
• Incorrect maintenance or use of spare parts
other than original spare parts provided by the
manufacturer
• Alterations to the product without express permission
from the manufacturer
• Use for purposes other than those described in this
manual
Dometic reserves the right to change product
appearance and product specifications.
6 Target group
Quantity
1
1
7 Configuring the battery
charger
An internal jumper must be set to select the necessary
charging curve depending on the type of house battery
used. The charging phases work independently of the
input energy source. The voltage and the supplied
current are continuously monitored for each charging
phase.
1. Unscrew the front cover.
The electrical installation and setup of the
device must be performed by a qualified
electrician who has demonstrated skill and
knowledge related to the construction
and operation of electrical equipment and
installations, and who is familiar with the
applicable regulations of the country in which
the equipment is to be installed and/or used,
and has received safety training to identify
and avoid the hazards involved.
All other actions are intended also for non-
professional users.
NOTICE! Damage hazard
If the charging curve for smart alternators/
Euro6 vehicles has been selected and the
ignition+ has been connected to the battery
charger instead of D+, do not leave the
power switched on for longer than 30 s.
EN
11
Publicité
