Publicité
Les langues disponibles
Les langues disponibles
All manuals and user guides at all-guides.com
TROUBLESHOOTING
Poor quality radio reception
The aerial signal may not be adequate. Try repositioning the aerial while watching the
signal strength. Signal strength can be displayed by tuning to a DAB station. Press the
INFO button then turn the TUNING knob,
.
PROBLEM
No sound / power
CD display does not
function properly / No
reaction to operation of
any of the controls
The CD skips tracks
Poor DAB/ FM reception
USB mode no reaction to
operation of any of the
controls
• Volume not adjusted. Adjust the volume.
• Mains cable not securely connected. Connect the mains cable
properly.
• CD contains non-audio/ Mp3 files. Press the TUN E button
repeatedly to skip to a CD or MP3 audio track, instead of the data file.
• Ensure the FUNCTION is select to the correct operation mode.
• Ensure the current MODE is correctly selected.
• Electrostatic discharge. Switch off and unplug the unit.
Reconnect after a few seconds.
• No CD inserted. Insert a CD.
• CD badly scratched or dirty. Replace or clean the CD, see
Maintenance.
• Laser lens steamed up. Wait until lens has cleared.
• CD-R / CD-RW is blank or not finalized. Use a finalized CD-R / CD-
RW or a suitable CD Audio disc only.
• Make sure the CD is not encoded with Copyright protection
technologies, as some do not conform to the Compact Disc standard.
• Press the FUNCTION button to select CD mode.
• CD damaged or dirty. Replace or clean CD.
• Program is active. Quit program mode.
• A CD badly scratched or dirty may result in improper operation.
• Make sure FM aerial wire is fully extended.
• Electrical interference in your home can cause poor reception. Move
the unit away from them (especially those with motors and transformers).
• Electrostatic discharge. Switch off and unplug the unit.
Reconnect after a few seconds.
• No USB memory stick inserted. Insert a USB memory stick.
• Make sure the USB memory stick is not encoded with Copyright protection
technologies.
• Press the FUNCTION button to select USB mode.
•
USB drive manufacturer's non-compliance with the full USB 1.1/ 2.0
standard. Try others USB memory stick.
CAUSE /
SOLUTI
ON
Publicité
