All manuals and user guides at all-guides.com
GET TING STARTED
DAB/FM AERIAL
Before using your radio for DAB or FM reception, unwire and extend its length of FM
antenna at the back of unit. You may need to adjust the position of the antenna wire for maxing
signal strength.
CONNEC TING POWER
Before connecting the power, check that the mains voltage on the rating plate is the
same as the voltage in your area.
· Plug the AC cord into the AC socket at the back of the unit.
· Plug the VDE plug into the wall socket.
· Press Standby button.
The unit is now ready for use.
NOTE:
When first connected to the power, the clock display will show "zeros".
SET TING THE CLOCK
The clock on your radio is automatically set when first used from the time signal broadcast
with DAB radio stations.
If a DAB station is not available, the clock may be set manually.
(Please refer to CLOCK SET page).
POWER CONTROL
STANDBY CONTROL
To turn the unit on:
· Press the STANDBY button on the top panel.
The display will light and the unit will switch on. To
turn the unit in STNADBY mode:
· Press the STANDBY button on the top panel briefly.
This unit will switch off. The clock will continue to run whilst mains power is connected.
ENERGY SAVING/ ERP2 REGULATION
This device is equipped with an AUTOMATIC SWITCH OFF / STANDBY SYSTEM for energy-saving
requirements. This is regulated by an EU-standard and is NOT A MALFUNCTION.