Télécharger Imprimer la page

Electrolux IK1910SZR Notice D'utilisation page 68

Masquer les pouces Voir aussi pour IK1910SZR:

Publicité

Les langues disponibles

Les langues disponibles

Problem
Temperature cannot be set.
The temperature in the appliance is
too low/too high.
Surfaces inside the fridge compart‐
ment are warmer.
DEMO appears on the display.
or
or
appears instead of
numbers on the temperature dis‐
play.
If the problem persists, contact the
Authorised Service Centre.
7.2 Replacing the lamp
For replacing the lamp, contact the
Authorized Service Centre.
68
ENGLISH
Possible cause
The FastFreeze function or Fast‐
Cool function is switched on.
The temperature is not set correctly. Set a higher/lower temperature.
The door is not closed correctly.
The food is too hot.
Too much food is stored at the
same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The FastFreeze function is switched
on.
The FastCool function is switched
on.
There is no cold air circulation in the
appliance.
The appliance is in the demo mode.
Temperature sensor problem.
7.3 Closing the door
1. Clean the door gaskets.
2. To adjust the door, refer to installation
3. To replace the defective door gaskets,
Solution
Switch off FastFreeze function or
FastCool function manually, or wait
until it deactivates automatically.
Refer to "FastFreeze function" or
"FastCool function" section.
Refer to the "Closing the door" sec‐
tion.
Let the food cool down before stor‐
age.
Store less food at the same time.
Defrost the appliance.
Open the door only if necessary.
Refer to the "FastFreeze function"
section.
Refer to the "FastCool function" sec‐
tion.
Ensure cold air circulation in the ap‐
pliance. Refer to the "Hints and tips"
chapter.
This is normal.
Press and hold the OK button for
approx. 10 sec until you hear a long
sound and the display turns off for a
short time.
Contact the Authorised Service
Centre. The cooling system will con‐
tinue to keep food cold, but temper‐
ature adjustment will not be possi‐
ble.
instructions.
contact the Authorized Service Centre.

Publicité

loading