Dal Zotto WANNA IDRO Manuel Utilisateur page 52

RESET
Allows the user to reset all values modi able by the user to the default values.
CONTROLS PROCEDURE
Press key 6.
Š
Proceed by pressing key 2 until USER MENU is displayed.
Š
Con rm using key 6.
Š
Press key 2 until RESET is displayed.
Š
Press keys 4-5 to select ON and press key 6.
Š
''DONE'' will appear on the display to con rm.
Š
LOW
The following menu allows the user to adjust the percentage of pellet feed.
If the stove has functioning problems owing to the quantity of pellets, adjust pellet feeding directly from the control board.
The problems correlated to the amount of fuel can be divided into 2 categories:
NO FUEL:
Š the stove is never able to develop a suitable ame, tending to remain very low even at high power.
Š at minimum power the stove tends to almost switch-o putting the stove in "
Š when the stove displays the "
EXCESS FUEL:
Š the stove develops a very high ame even at low power.
Š the panoramic glass is very dirty, obscuring it almost totally.
Š the burn pot tends to become encrusted, blocking the holes for air intake due to excessive pellet loading, as it is only burned partially.
The adjustment to be performed is in percentages. Therefore changing this parameter will lead to a proportional variation of all stove
feeding speeds. Feeding is from -30% to +20%.
CONTROLS PROCEDURE
Press key 6.
Š
Proceed by pressing key 2 untilUSER MENU is displayed.
Š
Š Con rm using key 6.
Press key 2 until "PELLET" is displayed.
Š
Use keys 4 - increase 5 to(4) or decrease (5) the load during the WORK stage.
Š
Š Press key 1 several times to con rm and exit the menu.
SET CHRONO
This stage is used to program when the generator automatically turns on and o .
The factory setting for SET CRONO is disabled on the generator.
The chrono allows the user to program 4 time spans within a day to use every day of the week.
The switch-on and switch-o time can be set in every time slot, along with the days of use of the programmed time slot and the
desired water temperature (65 - 80°C).
The setting of the current day and time is essential to ensure the chrono operates correctly.
RECOMMENDATIONS
Before using the chrono function, set the current day and time. Therefore check that the points listed in the "Set clock" sub-chapter have been
followed, so that the chrono function works. Aside from programming it, activate it as well.
The ignition and switch-o times must be within the arc of one day, from 0 to 24 and not over several days:
Example:
52
" alarm, there may be non-burned pellets inside the burn pot.
NO PELLETS
CORRECT
Switch-on time 07:00
Switch-o time 18:00
"NO PELLETS
ENGLISH
" alarm conditions.
INCORRECT
Switch-on time 22:00
Switch-o time 05:00