Dal Zotto WANNA IDRO Manuel Utilisateur page 45

CONTROL PANEL
BUTTON
ON/OFF
1
2
3
ADJUSTMENT
OPERATING POWER
DISPLAY ICONS KEY
Indicates the receipt of the radio signal
On = during radio communication
O = no radio communication
Flashing = serial port excluded
Indicates the presence of an alarm.
On: indicates the presence of an alarm
O : indicates the absence of alarms
Flashing: indicates the deactivation of the depression sensor.
Indicates the water temperature status
O = the T° read by the probe is above the set temperature
On = the T° read by the probe is below the set temperature
It indicates fumes motor operation.
O = fumes motor disabled
On = fumes motor active
Flashing = breakdown (contact technical after-sales service)
It indicates tangential fan operation (where applicable)
O = not working
On = working
Flashing = motor at minimum
It indicates pellet feed motor operation
O = pellet feed motor disabled
On = pellet feed motor active
It indicates pump operation
O = pump deactivated
On = pump active
Flashing = the safety device is active (H2O temperature > 85°C)
DISPLAY OF VARIOUS
TEXT MESSAGES
OFF
Indicates the stove modulation
On = the stove is working at the set power
Flashing = the power at which the stove is working is di erent to
the power set, the stove is modulating (for various reasons)
It indicates weekly programming functioning
Indicator on = weekly programming active
Indicator o = weekly programming disabled
Indicates the contact of the external additional thermostat
Closed contact on = the contact of the external additional
thermostat is closed.
Open contact on: the contact of the external additional thermostat
is open.
Flashing with contact closed: the contact of the external additional
thermostat is closed and the STBY function is activated
Flashing with contact open: the contact of the external additional
thermostat is open and the STBY function is activated
ENGLISH
TO ACCESS
THE MENU
6 4
5
SETTING
TEMPERATURE
-
-
-
-
45