Dal Zotto WANNA IDRO Manuel Utilisateur page 41

INSTANT DOMESTIC HOT WATER PRODUCTION KIT
Warnings: if the instant hot water production kit is to be used, contact the company technical after-sales service.
STOVE POSITIONING
For correct product functioning, it is recommended to position it in a way that it is perfectly level, with the aid of a spirit level.
REARMING
The gures below show the positions for rearming the tank (85°C) and H2O (100°C).
We recommend contacting a quali ed technician in the event rearming occurs to verify its cause.
WANNA IDRO
85°C
100°C
THERMO PRODUCTS FEATURES
Water content of the thermo product heat exchanger (l)
Volume of expansion vessel integrated into thermo-product (l)
Maximum content of water in the system for integrated expansion vessel (l)*
3 bar safety valve integrated into the thermo-product
Minimum and maximum pressure switch integrated into the thermo-product
Pump integrated into the thermo-product
Pump max. head (m)
*Content of water in the system in addition to that of the thermo
product that can be managed with the integrated expansion vessel.
An additional expansion vessel must be installed for a higher content
of water.
The following graph shows the behaviour of the circulator pump used
on our thermo-products at the speeds that can be set.
7
6
5
4
3
2
1
0
0 0,5
ENGLISH
1 1,5 2 2,5 3
Flow rate (m /h)
3
13
6
23
YES
YES
YES
6
3,5
41