NORAUTO NO8147-C006 Manuel D'utilisation Et Informations Sur La Sécurité page 54

left and right tether positions as shown in the image. Place the child in the seat ensuring
EN that the top of the shoulder straps are in the correct shoulder position and not close to
the child's neck.
[Fig. 6a-6d]
10 Installed in forward facing position with ISOFIX and Support Leg (76-105cm), use ISOFIX,
use Support Leg. Remove Seat "Cradleyou" Reducer (12).
11 Unfasten the shoulder straps from their initial position. Insert the shoulder straps in the
left and right tether positions as shown in the image. Place the child in the seat ensuring
that the top of the shoulder straps are in the correct shoulder position and not close to
the child's neck.
[Fig. 6e-6h]
12 Installed in forward facing position with ISOFIX and belt or only adult seat belt (100-150cm).
Use ISOFIX. If you don' t have ISOFIX connectors, ignore this step. Install the child safety
seat using the vehicle belt.
13 Pull out the belt from the belt ALR (Automatic Locking Retractor). Diagonal belt through
the same side of guidance (14) on headrest, then pull the diagonal belt and lap belt
together through the other guidance (17) on the base. Keep the diagonal belt at the
position of belt guidance (14) between the outside of the neck and shoulder (in the middle
of point and point).
14 Lock the tip of the buckle into the vehicle seat buckle with a clicking sound. Follow the
direction of arrow to tighten belt and put redundant belt into ALR. Shake the child safety
car seat to make sure it is securely attached.
[Fig. 6i-6l]
USING THE SIDE IMPACT PROTECTION SYSTEM (SIPS)
TIP
• Pop out the SIPS (13), when baby is in the seat, this can more effectively improve the safety
performance of the baby car seat.
1 Popping out method: pull the SIPS protrusion outward, and you can hear a clicking sound
when you pull it to the outer most side. If you don' t want to use the pop out component,
press the button inward and push the SIPS protrusion inward to the innermost.
54
CLICK