EUROM Spirit 1500 Manuel D'utilisation page 24

1. Hanging on the ceiling
The device must be hung on a concrete ceiling. Never hang it on a ceiling made of
wood, plaster or any other material! The attachment materials and fire safety
measures are not suitable for this type of installation.
 Seek a location in the ceiling that fulfils all of the requirements;
 Drill a sufficiently deep hole with a diameter of 8
mm;
 Knock the key-bolt with hanging eye into the hole;
secure it by turning clockwise and check that the
hanging eye is screwed into the key-bolt properly or
that the bolt and eye is firmly attached. Ensure that
the attachment kit can bear the weight of at least
10 kg.
 Attach the attachment chain with the screw locking at the device.
 Hook a karabiner hook at the ring of the attachment chain
 Hang the device on the hanging eye with the karabiner hook so that the device is
50 cm from the ceiling.
 Check that the karabiner hook is correctly closed.
2. Hanging on a frame (e.g. a tent frame)
Make sure that the device can hang freely from the attachment point you have
selected and that it is sufficiently sturdy to bear the weight of the device. Secure it
properly so that it cannot sag, slide or move in any other way.
 Seek a location in the frame that fulfils all of the requirements;
 Use the additional security chain with a karabiner hook at each end to secure
effectively:
- Hook the security chain to the ring on the hanging chain that is attached to the
device, using the karabiner hook;
- Wind the security chain around the frame once or twice;
- Then attach the second karabiner hook also to the ring at the hanging chain;
this will ensure that the device remains 50 cm from the frame.
 Check that the karabiner hook is closed properly and that the device is securely
attached. It should not slide, sag or move at all!
Take care! The control box must be positioned at least 50 cm from the tent
canvas, cover or any other item!
The following applies to both methods
 Run the electrical cable along the hanging chain and secure at multiple points
with a tie-wrap. Make sure that the cable is tight along the chain but do not hang
the device on the cable! Run the electrical cable from the (hot) device to a
socket.
 Your device is now ready for use.
24