Teka TB95C31X Notice D'utilisation page 4

Before performing any maintenance operation, disconnect the appliance from the gas supply and electricity network.
To replace parts such as knobs and burners, just remove them from the seats without disassembling any part of the cooker.
To replace parts such as nozzle supports, valves and electric components follow the procedure described in the burner
adjustment paragraph. To replace the valve or the gas thermostat, it is also necessary to disassemble the two rear gas train
brackets, loosening the 4 screws (2 per bracket) that attach it to the rest of the cooker and, unscrew the nuts that attach the
front burner valves to the control support, after removing all the knobs. To replace the gas or electric thermostat, also
disassemble the rear cooker guard, loosening the relative screws, to be able to pull out and reposition the thermostat bulb.
To replace the oven bulb, just unscrew the protection cap that projects out inside the oven.(fig.11)
WARNING: Before replacing the bulb, disconnect the appliance from the electric power supply.
Greasing the valves:
If it becomes difficult to operate the valve, it should be greased immediately by following the instructions listed below:
1) Disassemble the valve body by loosening the two screws located on the body of the valve (fig.12).
2) Extract and clean the seal cone and its housing with a rag soaked with thinner.
3) Lightly grease the cone with a special grease.
4) Insert the cone, moving it several times, remove it again, remove the excess grease and make sure that the gas passage
ways are unobstructed.
5) Replace all the pieces by reversing the order in which they were disassembled and check that the valve operates correctly.
GAS BURNER DIMENSION
Burner
Auxiliary
Semi-rapid
Rapid
Fish
Ultra-rapid
CONTROL PANEL DESCRIPTION
On the control panel, small symbols show the function of each knob or key. Here as follows are the several controls
that a cooker can have:
the symbol shows the disposition of burners on the worktop, the full dot identifies the burner in object (in this case the
rear burner on the right).
the symbol or
oven, 9 positions switch)
the symbol or
the symbol shows the oven fan working button as to allow the oven to operates with fan assisted gas. The fan operation
of the oven prevents the operation of the grill, which therefore cannot be used with the fan in action.
the symbol shows the minute minder
the symbol shows the operating key for the rotisserie (only gas oven)
the symbol shows the ignition key for the oven light (all except the electric fan oven)
the symbol shows the push-button for burner ignition
the symbol shows if keys are in position "on" or "off"
APPLIANCE MAINTENANCE
USE AND MAINTENANCE MANUAL
Dimension (mm)
Ø 50
Ø 70
Ø 95
55x230
Ø 130
shows the running of any oven (gas oven, gas oven with gas grill, gas oven with electric grill, static
shows the grill (gas grill, electric grill)
REPLACING PARTS
4