SilverCrest SFK 16 B2 Instructions De Montage, D'utilisation Et Consignes De Sécurité page 49

enters synchronizing mode for approx. 1 minute.
During the synchronizing mode, the signal
LED steadily lights up in blue and green
4
color. You will hear two beep indicate the
synchronization mode was closed.
You can also manually enter synchronising
mode by holding the signal type selection
button for approx. 3 seconds.
1
The signal LED on the receiver will flash
4
green and blue twice and a beep will hear, to
indicate that the receiver is in synchronizing
mode. You will hear two beep indicate the
synchronization mode was closed after
10 seconds.
Press the ringer button of the transmitter,
7
while the receiver is in synchronise mode. If
the receiver receives the signal, you will hear
two beep to indicate that the synchronization
is successful.
GB/IE 49