Télécharger Imprimer la page

ETNA KI560K Serie Mode D'emploi page 56

Publicité

Les langues disponibles

Les langues disponibles

BEFORE FIRST USE
Minimum pan diameter
The diameter of the bottom of the pan must be at least 140mm.
You will achieve the best results by using a pan with the same diameter as the zone.
If a pan is too small the cooking zone will not work.
Attention
Grains of sand may cause scratches which cannot be removed. Only put pans with
a clean bottom on the hob. We recommend that you lift pans and not slide them
over the hob.
Pan detection
If the hob does not detect a (ferrous) pan after a power level has been set, the pan detection
symbol flashes in the display. After 1 minute the cooking zone switches off.
If you remove a pan from the cooking zone during cooking, the pan detection symbol
shows. The cooking zone switches off. The symbol disappears when you put the pan back.
The cooking zone switches on again with the power level that was set before.
Power level setting
The cooking zones have 10 power levels (0-9) and a 'boost' level (P). Set the cooking level by
turning the knob clockwise. The cooking zone starts to operate at the level set.
Boost function
You can use the boost function to cook at the highest power level during a short period of time
(max. 5 minutes). After 5 minutes, the power is reduced to setting 9.
EN 8

Publicité

loading

Ce manuel est également adapté pour:

Kis560k serieKi560kzt