Kenwood KRC-3002 Mode D'emploi page 10

Connections
CAUTION
Connect a
KRC-3002
KENWOOD
car
audio power
amplifier to the
foot fy TO FM/AM antenna PREOUT j acks.
Ignition key switch
@ {To ignition)
J.
Fuse 5A Memory back up lead (Yellow)
Boma (To battery)
Power supply lead |
Fuse 1A
Ground lead (Black) © (To car chassis)
Power antenna control lead (Light blue)
(To fullautomatic power antenna)
When connecting to 2 speakers
When connecting to 4 speakers - (BTL connection)
Front left (Green)
(
| —_-_-__+«8 ©
{ Front left
(Green/Black) speaker
BO
1
i
; Front right (Gray)
'
i
————————18 © .
Front right
(Gray/Black) speaker
\__-+- 4p ©
Left
| (Green/Biack) speaker
(Gray)
7 (Gray/Black)
@® «D—
Rear left (White) (White)
-—-———«8 fy =
2 Rear left :
(White/Black) speaker (White/Black)
ae © Eh 0 &—-
Rear right (Purple) {Purple}
Right
(Purpte/Black) speaker
aed oe
RS ae ae oa aes rs See,
1
I
! i QO ce>
»! Rear right
7) (Purple/Black) speaker
: —____—«<a2 © &}—
e As the unit uses BTL output, always connect the black stripe speaker wires to the © ter-
minals of the speaker systems. Never let any speaker wires touch and never connect them
to the chassis (ground). Do not let the speaker terminals come into contact with the
chassis (ground).
Insulate any unused output wire to prevent a short circuit.
10 ten)