Bodet Harmonys Flash Manuel D'installation Et De Mise En Service page 6

ENGLISH
3. INSTALLATION
3.1. Mounting and connection(s)
Define the location of the Harmonys Flash by ensuring that the network cable is close by.
Look for the location that is less exposed to light sources for ensuring better contrast and great
visibility of the product for all people present in the room.
Install the product by following the steps below:
fig. 1
1
1 Open the Harmonys Flash casing using a flat screwdriver.
Place the screwdriver in the slot provided, located under the product.
2
Remove the cover using the tip of the screwdriver as a lever to separate the cover from the mounting
plate. Do not insert the screwdriver more than 1 cm into the slot, otherwise the electronic board can
be damaged.
3
Remove the front panel of the product.
4
Carry out the mounting of the Harmonys Flash to its location using 3 fixing screws.
5
Ensure that the Harmonys Flash is held firmly against the wall.
6
Connect the RJ45 Ethernet cable to the product (socket located on top of the product).
7
Replace the front panel of the product.
6
3
4
70
130
44
2
5
6
7