Bodet Harmonys Flash Manuel D'installation Et De Mise En Service page 12

ENGLISH
4.4. "Alarm configuration" menu
The "Alarm configuration" menu enables to activate product monitoring, define information to be transmitted
as well as the destination server. It is possible to select one or several parameters to define as alarms and
configure them.
• SNMP checkbox:
• Version checkbox:
• Community :
• SNMP Trap checkbox:
• SNMP Manager 1/2/3:
• Checkboxes
Active alarms:
Reboot: An alarm is triggered when a user restarts the product.
Scheduled melody: An alarm is triggered when a scheduled melody is broadcast.
Manual melody: An alarm is triggered when a melody is broadcast manually.
Alert melody: An alarm is triggered when an alert melody is broadcast ("Alert" mode active
Web access: An alarm is triggered when a user connects to the product web server.
Authentication failure: An alarm is triggered when a user incorrectly logs in to the product web server.
Repeater failure: An alarm is triggered in case of repeater failure.
12
Enabling / disabling the SNMP protocol.
Selecting the version of the SNMP protocol.
A set or a domain of Harmonys Flash devices defined by the user. It is essential
that all Harmonys Flash in the network have the same "Community" name.
Enables or disables automatic sending of error messages to the SNMP
Manager(s)
IP addresses of servers receiving product feedbacks. SNMP managers
redundancy increases the reliability of alarm feedbacks.
in the Sigma software).