Bodet Harmonys Flash Manuel D'installation Et De Mise En Service page 11

4.3. "Parameters" menu
The "Parameters" menu enables to configure the functional settings of the device:
"Multicast addresses" section
• Multicast addresses
(Address A and B) :
• Brightness:
• Zone number :
"Repeater" section
• Checkboxes
Repeater:
• Repeater address:
The "Save" and "Save and Reboot" buttons enable to save data modified in the device in question, and
restart it.
Multicast addresses for sending flashing commands
(by default: A: 239.192.55.1, B: not indicated).
4 levels of brightness (25%, 50%, 75% and 100%) depending on where the product
is installed (with low or high sun exposure...).
Number of the zone in which the product is installed.
- Client repeater / Server repeater:
In the case of a complex network installation with one or several remote sites, it can
be necessary to use network gateways. To do so, it is necessary to define repeaters
that will carry information from one network to another.
On each pair, one Harmonys Flash is defined as server and the other as client.
Check the "Client repeater" or "Server repeater" box depending on the function
required. It is recommended but not mandatory to place the server repeaters in the
network where the Sigma master clock is located.
- Multisite repeater:
When using the Harmonys Multisite software, the repeater establishes a Unicast
connection to the server of a monitoring centre. If the device is used as repeater
when using this software, check the "Multisite repeater" box.
It is recommended that the Multisite repeaters are placed near an administrative
or technical room and that the same type of repeater equipment are used in each
site: Harmonys, Harmonys Trio or Harmonys Flash.
Depending on the selection made for the "Repeater" function:
- Client / Server: network address of the other Harmonys Flash in the repeater pair.
- Multisite: network address of the Multisite server.
ENGLISH
11