Husqvarna PG 6 S Manuel D'utilisation page 18

1. Turn the STOP/RUN switch (A) on the control panel
counterclockwise to 0 to stop the grinding head.
2. Keep the tool plates against the surface until they
stop fully.
CAUTION:
asphalt, paint or equivalent material,
the product can attach to the adhesive
surface. Immediately after the tool plate
stopped fully, lift up the front of the
grinding head a small distance.
3. Turn the ON/OFF switch (B) on the control panel
to 0 to stop the product. The LED adjacent to the
ON/OFF switch goes off.
4. Disconnect the power plug.
To reset the product
The ON/OFF switch can be used as a reset switch if the
inverter releases. Reset the product when the indicator
inverter to the grinding motor (A) is red.
A
1. Turn the STOP/RUN switch (B) counterclockwise to
0 to make sure that the grinding head is off.
2. Turn the ON/OFF switch to the arrow position (C) to
reset the product. The indicator for the inverter to the
grinding motor is green when the fault is reset.
18
A B
If you grind adhesive
B C
3. Turn the STOP/RUN switch on the control panel
clockwise to start the grinding head again.
Weights
The product can have 1 weight (accessory) on each
side of the product. If the product is heavy to operate,
adjust the weights to change the pressure on the
grinding head. The weights must be adjusted to the
same position on the right and the left side. The weights
have 3 positions:
• Position 1: Maximum pressure on the grinding head.
This position increases the operation effect. This
position is also used when you set the product in
transport position.
• Position 2: Standard pressure on the grinding head.
• Position 3: Minimum pressure on the grinding head.
This position is also used when you tilt the product to
servicing position.
2288 - 005 - 24.05.2024