Publicité
Les langues disponibles
Les langues disponibles
1. Pull the lock lever (A) on the handle in the direction
of the control panel and hold it in this position.
2. Adjust the handle (B) to an applicable operation
height.
3. Release the lock lever on the handle to lock the
handle position.
4. Loosen the 4 screws (C) on the handlebar.
D
C
5. Adjust the handlebar (D) to an applicable operation
height.
6. Tighten the 4 screws (E) on the handlebar to lock the
handlebar position.
To connect the product to a power
source
1. Connect the power plug of the product to the
extension cable.
2. Connect the extension cable to a mains outlet.
3. Engage the support frame. Refer to
disengage the support frame on page 12 .
16
A
B
E
To engage and
4. Hang the power cord on the suspension device on
the support frame to prevent tension in the power
cord.
5. Disengage the support frame.
CAUTION:
connected to a dust extractor, the dust
extractor must be connected to a 3-phase
power source.
Operation speed
If the product is operated on a new surface type, set
the speed to 70% initially. When the operator knows the
surface type, the speed can be adjusted.
Direction of rotation of the grinding
discs
Seen from above the product, the direction of rotation is
as follows:
•
right arrow: clockwise
•
left arrow: counterclockwise
During operation the product can pull to the side. The
direction of the pull is related to the direction of rotation.
The product pulls to the right when the direction of
rotation is set to the left. The product pulls to the left
when the direction of rotation is set to the right.
The side pull can help you operate the product for
example near a wall. Set the direction of rotation to pull
in the direction of the wall.
CAUTION:
Make sure that the product only lightly
touches the wall. The product is heavy and
can cause damage.
When the product is
Steer the product carefully.
2288 - 005 - 24.05.2024
Publicité
