Husqvarna PG 6 S Manuel D'utilisation page 15

To connect a dust extractor
WARNING:
extractor if the dust extractor hose is
damaged. The risk increases that you
breathe in dust that is dangerous to your
health. Use approved respiratory protection.
1. Examine the dust extractor hose for damages.
2. Make sure that the filters in the dust extractor are
clean and not damaged.
3. Make sure that the STOP/RUN switch on the control
panel is set to 0.
4. Connect the dust extractor hose to the product.
5. Engage the support frame. Refer to
disengage the support frame on page 12 .
6. Hang the dust extractor hose on the suspension
device on the support frame to prevent tension in
the dust extractor hose.
7. Disengage the support frame.
Handle positions
• Operation position of the handle:
2288 - 005 - 24.05.2024
Do not use the dust
To engage and
• Transport position of the handle:
• Servicing position of the handle:
To adjust the handle and the handlebar
WARNING:
the handle and the handlebar. Make sure
that the handle and the handlebar locks into
position. The moving parts can cause injury.
Set the handle height as close as possible to the height
of the operators hip. During operation the product can
pull to the side. The hip of the operator can help to stop
this movement to the side.
Be careful when you adjust
15