Husqvarna PG 6 S Manuel D'utilisation page 17

To change the speed and direction of rotation
of the motor
Change the direction of rotation regularly to increase
the life and the sharpness of the diamond tools. The
diamond tool segments are used equally and the contact
surface continues to be as large as possible.
• To set the speed and direction of rotation of the
grinding disc, turn the knob.
To operate the product
• Operate the product manually with the control panel
on the handle. Refer to
PG 6 S on page 3 and Product overview, right side
PG 8 S on page 5 .
• During operation, look for color changes in the
indicator for the inverter to the grinding motor (A).
• Green light: the product operates correctly.
• Orange light: there is an overload in the grinding
head. Decrease the power output in 10 seconds
or less to prevent that a fault occurs.
• Red light: fault in the inverter and the grinding
head stops. It is necessary to reset the product.
To reset the product on page 18 .
Refer to
2288 - 005 - 24.05.2024
Product overview, right side
A
To start the product
CAUTION:
time while the grinding head is on. If you
do not move the product, the surface can
become rough.
1. Push down the handlebar slightly to lift the grinding
head from the surface. This releases the surface
friction of the diamond tools. Do not lift the grinding
head fully from the surface during operation.
2. Turn the STOP/RUN switch (A) on the control panel
counterclockwise to 0 to make sure that the grinding
head is off.
3. Turn the ON/OFF switch (B) on the control panel
to the arrow position to start the product. The LED
adjacent to the ON/OFF switch comes on.
4. Turn the STOP/RUN switch on the control panel
clockwise to start the grinding head. In less than 5
seconds, the product operates at idle speed.
To stop the product
CAUTION:
from the surface when you stop the motor.
The tool plates rotate for a while after the
motor stops. Dust can go into the air and the
surface can become damaged.
CAUTION:
become stationary until the tool plates stop
fully.
Move the product all the
A B
Do not lift the grinding head
Do not let the product
17