Publicité
Les langues disponibles
Les langues disponibles
•
Keep the extension cable away from heat, oil, sharp
edges or moving parts. A damaged cable increases
the risk of electrical shock.
•
Make sure that the extension cable is in good
condition and not damaged.
•
Do not use the extension cable while it is wound up.
This can cause the extension cable to become too
hot.
•
Make sure that the extension cable is behind you
and the product when you use the product. This
prevents damage to the extension cable.
Safety devices on the product
WARNING:
instructions that follow before you use the
product.
•
Do not use a product with safety devices that are
damaged or do not operate correctly.
•
Do a check of the safety devices regularly. If the
safety devices are damaged or do not operate
correctly, speak to your Husqvarna service agent.
•
Do not make modifications to safety devices.
Emergency stop button
The emergency stop button is used to quickly stop the
motor. The emergency stop button breaks the mains
power supply.
CAUTION:
stop button as the stop button for the
product.
Introduction
WARNING:
product, you must read and understand the
safety chapter.
2288 - 005 - 24.05.2024
Read the warning
Do not use the emergency
Operation
Before you operate the
To do a check of the emergency stop button
1. Turn the emergency stop button (A) on the control
panel clockwise to make sure that the emergency
stop button is disengaged.
2. Turn the ON/OFF switch (B) on the control panel
to ON to start the motor. The LED adjacent to the
ON/OFF switch comes on.
3. Push the emergency stop button.
4. Make sure that LED adjacent to the ON/OFF switch
goes off.
5. Turn the emergency stop button clockwise to
disengage.
Safety instructions for maintenance
•
Keep all parts in good condition and make sure that
all fixtures are correctly tightened.
•
Do not use a product that is defective. Do the safety
checks, maintenance and the servicing as given in
this manual. All other maintenance work must be
done by an approved service agent.
•
Stop the product when you replace the diamond
tools. Turn the ON/OFF switch to 0 and push the
emergency stop button.
•
Do the inspection and/or maintenance with the motor
stopped and the power plug disconnected.
•
Do the maintenance to make sure that the product
operates correctly. Refer to
on page 19 .
A
B
Maintenance schedule
11
Publicité
