Bitzer CM-RC01 Instructions D'installation page 26

1 Introduction
The intended use of the BITZER gateway is to enable easy connection of any BITZER IQ device to the internet,
more specifically the BITZER DIGITAL NETWORK (BDN, access via MyBITZER). This document describes the in-
stallation and setup of the gateway for
• compressor modules CM-RC and CM-SW
• compressor protection device SE-i1
• CSV. compressors
• condensing units ECOSTAR and ECOLITE
Scope of delivery and setup can change due to further product improvements.
Gateway box
Gateway kit
Tab. 1: Gateway box and gateway kit
Fig. 1: Gateway box (part no. 347 990 01) for installation with BITZER condensing units (gateway outlined by green line)
CT-311-5 // PDF Download
gateway and power supply mounted in plastic housing (IP56)
gateway and power supply to be mounted in the switch cabinet
resistor 120 Ohm
Modbus termination
3G gateway box
26