Publicité
Les langues disponibles
Les langues disponibles
en
Tips on energy saving
■ Touch C. The appliance has finished
cleaning and is ready for use again.
■ Touch E to exit the programme.
Calc'nClean
Takes about 26 minutes.
calc'nClean combines the functions Descale
and Clean. If both programmes are due
to be carried out close together, the fully
automatic coffee machine will automatically
suggest this service programme.
■ Touch E.
■ Select "Calc'nClean" with the K or L
arrow button.
■ Touch C. The display indicates the
progress of the programme.
■ Clean the beverage outlet and replace,
empty the drip trays and replace.
■ Open the ground coffee drawer, drop in
a cleaning tablet and close the coffee
drawer again.
■ Remove the water filter (if there is one)
and touch C.
■ Pour lukewarm water into the empty
water tank up to the "0.5 l" mark and
then dissolve one Neff descaling tablet
00576693 in it.
F
If there is not enough descaling
solution in the water tank, you will be
asked to do the following. Refill using
uncarbonated water and press C
again.
■ Remove the suction pipe from milk
container, wipe it and insert the end of the
suction pipe into the hole on the coffee
grounds container.
■ Close the appliance door.
■ Place a container with a capacity of
0.5 litre under the beverage outlet.
■ Touch C.
The programme will now run for about
19 minutes.
■ Remove the container and touch C.
■ Rinse the water tank and (if removed)
replace the water filter.
■ Fill the tank with fresh water up to the
"max" indicator.
56
■ Replace the water tank and close the
door.
■ Place the container underneath the bev-
erage outlet again.
■ Touch C.
The programme will now run for about
7 minutes and rinse the appliance.
■ Remove the container, empty the drip
trays, replace and close the appliance
door.
■ Touch C. The appliance is descaled,
cleaned and ready for use again.
■ Touch E to exit the programme.
Special rinsing
F
Important: If any of the service
programmes is ever interrupted, for
instance by a power failure, please
proceed according to the information
on the display:
■ Rinse the water tank and refill it with fresh
water up to the "max" mark.
■ Touch C. The programme will now
run for about 2 minutes and rinse the
appliance.
■ Empty the drip trays, replace and close
the appliance door. The appliance is
ready for use again.
■ Touch E to exit the programme.
Tips on energy saving
■ Touch I to switch the appliance to
"energy saving mode". The appliances
uses very little power when in "energy
saving mode", but monitors all safety-rel-
evant functions so as to avoid damage.
■ In the menu under "Switch off after",
set the automatic switch off period to
15 minutes.
■ Reduce the brightness of the display
and the illumination in the menu to save
energy.
■ If possible, do not interrupt the dispensing
of coffee or milk froth. Stopping a process
prematurely results in higher energy
consumption and the drip tray fills up
more quickly.
Publicité
