Publicité
Les langues disponibles
Les langues disponibles
en
Simple troubleshooting
Problem
Display shows
"12:00"
Display shows
"Milk container connected?"
despite connected milk
container.
Display shows
"Overvoltage or
undervoltage"
Display shows
"Leave device to cool"
Display shows, for
example:
"Fault: E0510"
Display shows
"Fill bean container"
although the container is
already full, or the grinder
is not grinding any beans.
Display shows
"Clean brewing unit"
Display shows
"Refill with still water or
remove filter "
Display shows
"Empty drip trays"
despite them being empty.
60
Cause
Power failure or appliance
switched off at mains.
Container is outside the
range of the sensor.
Material e.g. milk carton is
not recognised.
Voltage too high or too low.
Appliance is too hot.
The appliance has a fault.
Beans are not falling into the
grinding unit (beans too oily).
Brewing unit is soiled.
Too much ground coffee in
the brewing unit.
The mechanism of the
brewing unit is stiff.
Water tank wrongly inserted Insert water tank correctly
Carbonated water in the
water tank.
Float is stuck in the water
tank.
New water filter not rinsed
according to instructions, or
water filter used or defective.
Air in the water filter.
Drip tray is soiled and wet.
Emptying is not detected
when the appliance is
switched off.
Solution
Re-enter values; do not switch
the appliance off at the mains
or select the "Off" option in the
Clock display menu.
Position the container at the right
edge.
Confirm the display request with
"yes" or use the enclosed milk
container.
Contact electricity or grid pro-
vider. Have the power supply
checked by an expert.
Switch off appliance for
30 minutes.
Proceed according to the display
screen.
Gently tap the bean container.
Possibly change the type of
coffee. When the bean container
is empty, wipe it with a dry cloth.
Clean the brewing unit.
Clean the brewing unit. Do not
place more than two level meas-
uring spoons of ground coffee in
the drawer.
Clean the brewing unit, see the
section "Care and daily cleaning".
Fill the water tank with fresh tap
water.
Remove the tank and clean
thoroughly.
Rinse the water filter according to
the instructions and then switch
on, or use a new water filter.
Dip the water filter into water
until no more air bubbles escape,
replace the filter.
Clean and dry the drip tray
thoroughly.
When the appliance is switched
on, remove and re-insert the
drip tray.
Publicité
