Publicité
Les langues disponibles
Les langues disponibles
Problem
Water flows inside the refrigerator.
Water flows on the floor.
The temperature in the appliance is
too low/too high.
If the advice does not lead to the desired
result, contact the nearest Authorised
Service Centre.
Replacing the lamp
The appliance is equipped with a long-
life LED interior light.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
Caution! Disconnect the plug from the
mains socket.
1. With your fingers, spread slightly both sides of the
transparent cover to unhook them and detach the
cover pulling it in the direction of the arrows.
22
Possible cause
Food products prevent the water
to flow into the water collector.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative tray
above the compressor.
The temperature regulator is not
set correctly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The thickness of the frost is
greater than 4-5 mm.
The door has been opened often.
There is no cold air circulation in
the appliance.
2. Replace the lamp with the one that has identical
characteristics and is specifically designed for
household appliances.
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door.
Make sure that the light switches on.
Closing the door
1. Clean the door gaskets.
Solution
Make sure that food products do not
touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to the
evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door".
Let the food products temperature de-
crease to room temperature before
storage.
Add less food products at the same
time.
Defrost the appliance.
Open the door only if necessary.
Make sure that there is cold air circula-
tion in the appliance.
1
2
1
Publicité
