Filter Installation - IDEAL AP 100 Mode D'emploi

Set-up |
Installation and set-up

2. Filter Installation

All filters are assembled and packaged before being shipped out of the factory.
The packaging of filters must be removed before use.
 Failure to remove the packaging before operating the product may result in
malfunction.
Filters must be replaced only while the power is turned off.
1 Fine Mesh Cleancel® Pre-Filter,

3 Activated Carbon Filter installation
Push the two buttons on the filter
①
cover at the bottom of the product
towards the middle and take the
cover off by pulling it towards you.
Pull the new filter from the vinyl
②
packaging.
Remove the vinyl packaging from
③
the new filters.
X Failure to remove the vinyl packaging before use may result in
abnormal noise, product deformation or fire caused by
overheating of the motor.
2 Antimicrobial PM2.5 Filter,
- 55 -