ALFRA AP 600 Mode D'emploi page 25

DESIGN AND FUNCTION
• The operation of the unit is divided into the parameter level, the operator level and the initialisation level.
• All operating parameters can be set at the parameter level.
• The basic functions of the display (depending on the software version) are available at the user level.
• Only basic actions such as sensor calibration or resetting the unit to default parameters (factory setting)
are carried out at the initialisation level.
• All entries are made exclusively via the 4 front keys or their key combinations; the display is via the
integrated LCD.
Segments for numerical and text display
1
(incl. sign, decimal points, fraction display)
2 Symbols for unit of measurement or display mode
3 Symbols for active offsets 1...3 (offsets)
4 Battery status symbols
5 REF symbol: Device must be referenced
For various applications, the symbol for the unit of measurement can be changed by parameter (P02), e.g.
the "°" symbol for angle measurements.
The normalisation of the display value must be done manually via the multiplication factor (P08) and the
decimal point (P03).
For inch mode, the fraction display is also available.
25