GYS KRYPTON 321 DC TRI Mode D'emploi page 34

User manual
Spot
VaL
welding time
(s)
• Multi-Spot (Mode adjustable directly from the welding cycle)
This is a spot welding mode similar to TIG Spot, but with defined tacking and hold
times, as long as the trigger is held down.
Spot
VaL
welding time
(s)
Duration
VaL
between
2 points (s)
• Tack (Mode adjustable directly from the welding cycle)
This welding mode also allows for the pre-assembly of workpieces before wel-
ding, but in two stages this time: the first phase is pulsed DC to concentrate the
arc for better penetration, followed by a second phase in standard DC to widen
the arc, and therefore the weld pool, to ensure the spot.
The adjustable times of the two phases allow for better repeatability and non-oxi-
dised points.
34
Translation of the original
instructions
The tacking time is in the welding cycle after the gas station.
t.dC Man
The tacking time is in the welding cycle after the gas station.
t.dC Man
t.MU. 0.1
t.dC 60.0
The grayed-out areas are not available in this mode.
60.0
t.dC
t.MU. 25
The grayed-out areas are not available in this mode.
KRYPTON 231 DC FV / 321 DC TRI
t.dC
Validation of
the current
setting
Weld
SETUP
PRESS 3''
t.dC
Validation of
the current
setting
t.MU.
Validation of
the current
setting
Weld
SETUP
PRESS 3''
JOB
JOB