SilverCrest SWC 3100 B1 Mode D'emploi page 10

4) Rinse the kettle out with clear water.
5) Refill the appliance with water up to the MAX mark, and then bring it to the
boil. When done, pour this water away also.
6) Rinse the kettle out with clear water.
The appliance is now ready for use.
Boiling water
RISK! ELECTRICAL SHOCK!
► Never place the electrical base 4 close to water – this would be a
potentially fatal risk!
WARNING! RISK OF INJURY!
► Always use freshly drawn water. Do not consume any water that has already
stood in the kettle for longer than one hour. Do not reboil water that has cooled
down. Always pour old water away. Microbes could have formed in it!
NOTE
► Always ensure that the ON/OFF switch
the mains plug is unplugged and the appliance is standing on the base 4.
Otherwise the appliance could heat up unintentionally as soon as the
mains plug is plugged in again.
1) Lift the kettle off of the base when filling it!
2) Press the release button 1 and open the lid.
NOTE
► When filling it, hold the kettle upright. This is the only way to read the
markings on the scale 2 correctly.
3) Fill the kettle...
–
–
4) First close the lid, then place the kettle on the base 4, so that it sits securely
on the base 4.
5) Now insert the plug into the mains power socket.
6) Push the ON/OFF switch
WARNING! RISK OF INJURY!
► For safety reasons you should not open the lid when the water is boiling or
extremely hot. There is a risk of scalding.
SWC 3100 B1
to at least the MIN mark, so that the appliance does not overheat,
no further than the MAX mark, so that boiling water cannot spill out.
3 is not pressed down when
3 downwards so that it engages.
GB │ IE │ 7 ■