Gladiator GALG36KDYG Instructions D'assemblage page 6

4. Install Shelves
F3
Phillips-head screw (12)
P1
A
A. Middle pair of holes in cabinet side
IMPORTANT: Use the pair of holes located in the middle of the
cabinet sides to install a center shelf without the magnet (P5), so
the doors will lock. The other two shelves with magnet (P5m) may
be installed where desired.
1. Place the shelf (P5) without the magnet in the cabinet so that
the long edge with the two holes is facing out.
2. Align the holes in the shelf ends with the pair of holes in the
middle of the cabinet sides (P1).
3. Using two phillips head screws (F3) and flange nuts (F5) per
side, fasten the shelf (P5) to the sides (P1).
4. Determine where you want to place the other two shelves with
magnet (P5m). Align the holes in the shelf ends with the holes
in the cabinet side.
NOTE: Make sure the magnets in the long edges of the
shelves are facing the cabinet front.
5. Using two phillips head screws (F3) and flange nuts (F5) per
side, fasten the shelves with magnet (P5m) to the cabinet
sides (P1). Completely tighten the nuts.
6
F5
Small flange nut (12)
P2
P5m
P1
P5
P5m
P3
5. Install Doors
Phillips-head screw (6)
P2
P5m
P1
P5
A
P5m
P3
A. Phillips-head screws (F3)
IMPORTANT:
The door with the lock assembly (P7) should be installed on the
■
right-hand side of the cabinet.
The door hinges are designed with keyhole slots at the top
■
and bottom so the door will hang on the cabinet while you are
fastening the screws.
1. Start phillips-head screws (F3) in both the top and bottom
holes on each side of the cabinet.
2. Hang the right-hand side door (P7) from the top and bottom
screws, and hand tighten.
3. Insert the middle four phillips-head screws (F3) through the
door hinge into the cabinet and hand tighten.
4. Repeat steps 2 and 3 to attach the left-hand door (P6).
5. Align the doors and completely tighten the screws.
Complete the Assembly
1. Make sure there is a bolt or screw in each hole of the cabinet
frame.
2. Move the cabinet to its final location.
3. Place a level on an inside shelf, and if necessary, level the
cabinet by adjusting the height of the leveling feet. Turn to the
left to raise or to the right to lower the leveling foot.
4. If the doors are not aligned, loosen all the screws attaching
the door hinge to the cabinet. Adjust door to the desired
height, and fully tighten the screws.
F3
P7