Publicité
Les langues disponibles
Les langues disponibles
2.
Attach Back Panel
Phillips-head screw (34)
P1
P3
IMPORTANT:
Attach the back panels starting at the top of the cabinet with
■
back panel (AAA) and working down to the cabinet bottom.
Each back panel will overlap the panel below.
Do not completely tighten the screws until all back panels are
■
in place.
1. Align back panel (AAA) with the holes in the cabinet top. Using
seven phillips-head screws (F3), attach back panel (AAA) to
the cabinet top and sides.
2. Slide the top of back panel (BBB) under the bottom of back
panel (AAA). Using four phillips-head screws, fasten back
panel (BBB) to the cabinet sides.
3. Repeat Step 2 for the remaining back panels ending with back
panel (EEE).
4. Using two phillips-head screws, attach each back panel to the
panel below.
NOTE: Using three phillips-head screws, attach panel (EEE) to
the cabinet bottom (P3).
5. Completely tighten all back panel screws starting with the
sides and continuing with the top, middle and bottom.
6. Using the hex key (provided), completely tighten all 24 cabinet
bolts and nuts.
F3
P2
P1
3.
Install Leveling Feet
P1
P3
A. Leveling feet
To install leveling feet:
1. Place the cabinet on its side.
2. Screw a leveling foot (P4) into each of the four rivet nuts
located at the corners of the cabinet as shown.
3. Stand the cabinet upright.
4. If you have not already, fasten the two bolts at each front
corner, of the cabinet frame. Completely tighten all the cabinet
bolts and nuts.
P4
A
5
Publicité
