Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY
INSTRUCTIONS
Tools and Parts
F1
F2
5/16" Hex-
Flange nut (8) Phillips-head
head bolt (24)
Gather the required tools before starting installation.
Tools Needed:
1/2" Wrench
■
3/8" Wrench
■
Tool Supplied:
Hex key
■
Part Supplied:
Key
■
Unpack the Cabinet
1. Remove and verify the contents as shown in "Tools and
Parts."
2. Dispose of/recycle all packaging materials.
Assemble Cabinet
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT:
Two people may be required to complete the assembly.
■
As you assemble the cabinet, make sure the edges with the
■
holes are facing up.
If you are assembling the cabinet on the floor, fasten the eight
■
front corner bolts, two at each corner, after you stand the
cabinet upright.
4
F3
F5
Small flange
screw (52)
nut (12)
Phillips screwdriver
■
Level
■
1.
Cabinet Assembly
5/16" Hex-head bolt (24)
P1
P2
P2
1. Place side panel (P1) on a flat, firm surface so that the edge
with the holes is facing up as shown.
2. Insert the cabinet top (P2) between the edges of side panel
(P1).
NOTE: Make sure the edges with the holes are facing up.
3. Align the holes and attach the top (P2) to side panel (P1) using
six hex-head bolts (F1) and two 5/16" flange nuts (F2) as
shown. Do not tighten completely.
4. Position the other side panel (P1) so that the top (P2) is
between the edges of side panel (P1).
5. Align the holes and attach the top (P2) to the side (P1) using
six hex-head bolts (F1) and two 5/16" flange nuts (F2) as
shown. Do not tighten completely.
6. Insert the cabinet bottom (P3) between the edges of the side
panels (P1).
NOTE: Make sure the edges with the holes are facing up.
7. Align the holes and attach the bottom (P3) to the sides (P1)
using six hex-head bolts (F1) and two 5/16" flange nuts (F2)
for each side as shown. Do not tighten completely.
F2
Flange nut (8)
P3
P1
P1
Publicité
