Parkside Performance PPHSA 40-Li B2 Traduction Des Instructions D'origine page 38

GB MT
Cleaning
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
•­ Keep­clean­the­ventilation­slots­(
motor­housing­and­handles­of­the­appli-
ance.­Use­a­damp­cloth­or­a­brush.­Do­
not use cleaning agents or solvents. You
may­otherwise­irreparably­damage­the­
appliance.­
•­ Always­keep­the­equipment­clean.­After­
using­the­equipment,­it­is­imperative­to:
-­ Clean­the­blade­(with­an­oily­cloth);
-­ Oil­the­blade­­­­­­­
shaft with an oil
can­or­spray.­
Maintenance
•­ Prior­to­every­use,­check­the­appliance­
for obvious defects such as loose, worn or
damaged­parts.­Check­that­the­screws­in­
the safety knife bar (
• Check covers and safety devices (
2/3) for damages and correct installa-
tion.­Replace­these­if­necessary­or­have­
them­repaired­by­the­service­centre.
• You can smoothen minor nudges in
the cutting teeth yourself using a knife
grinder­to­sharpen­the­cutting­edges.­
The trimmer will only cut well if the
teeth­are­sharp.
• Blunt, bent or damaged knife bars to
be­replaced.­
Ask our service centre to carry out any
work that is not described in these instruc-
tions.­Use­only­original­parts.
38
5),
2)­are­tight.­
1/
Replacing the hand pro-
tection
1.­ Loosen­the­two­screws­on­the­hand­pro-
tection­(3)­with­a­Phillips­screwdriver­
(not included).
2.­ Replace­the­damaged­hand­protection­
(3).
3.­ Fasten­the­new­hand­protection­(3)­with­
the two screws.
Storage
Keep­the­device­in­the­blade­guard­(
supplied,­dry­and­out­of­reach­of­children.
•­ The­storage­temperature­for­the­re-
chargeable battery and the device is
between 0°C and 45°C. Avoid extreme
cold or heat during storage to ensure
the­battery­output­is­not­adversely­af-
fected.
Wall bracket
Suspension device on the underside
of the device (19)
•­ Using­dowels,­place­one­screw­at­the­
desired­position­on­a­wall.
• The screw head can have a diameter of
8­-­10­mm.
•­ Leave­the­screw­head­protruding­at­a­
distance­of­approx.­10­mm­from­the­
wall.
•­ You­can­place­the­device­onto­the­
screw­using­the­openings­on­the­blade­
and­pull­the­device­down­until­it­stops.
­ Slide­the­supplied­blade­guard­(
9)­up­when­hanging­the­device­on­
the wall for storage.
When drilling, be careful not
to damage any supply lines.
9)