Parkside Performance PPHSA 40-Li B2 Traduction Des Instructions D'origine page 36

GB MT
If­this­is­not­the­case,­read­on­if­

possible­
5.­If­you­select­"Go to add", the available
devices­are­displayed­in­a­list.
6. Select one of the smart batteries with
which you use the device check mark
Select­only­one­device­at­a­time.­If­there­
are other check marks for other devices,
clear­the­check­marks­by­pressing­them.
7.­Now­press­the­
lour as the set check mark.
8.­Confirm­the­successful­connection­with­
"Finish".­­
The device is now listed on the tab
"At home" and can be selected.

If­you­have­already­connected­other­
devices­to­the­app:
­"At home", select the
4. On the tab
in­the­upper­right.­The­app­scans­the­
area for available devices and indicates
if available devices have been found.
If­this­is­not­the­case,­read­on­if­

possible­
5. Proceed as with

If­a
list of available devices is not au-
tomatically suggested to you:
If­the­smart­battery­is­not­suggested­automa-
tically,­follow­these­steps:
­"At home", select the
4. On the tab
in­the­upper­right.
5.­Select­"Other" in the bar on the left.
6.­Select­"Lidl Smart Battery".
7.­Follow­the­instructions­in­the­app.

If­you­have­already­connected­the­
smart­battery­to­the­app:
4. Select the tab
5. Select the smart battery (that you are
using for the device). A symbol next
36
.
that has the same co-
.

­from­point 5.
­"At home".
to the smart battery indicates that the
smart battery is connected to a Perfor-
mance device.
Upgrading­the­firmware­can­change­
the­features­of­the­app.
.
Features of the app
Select one of the smart batteries you are
using­to­power­the­device.­This­will­take­you­
to­the­overview­page­where­you­will­find­
the following information:
-­ The­Tool Virtual ID­helps­you­identify­the­
exact tool
-­ The­Tool Model­and­production­batch­
are indicated
-­ The­Tool Discharge Current indicates the
current­discharge­in­amperes
-­ The­Tool Rotation Speed indicates the
revolutions­per­minute
-­ Tool in Working Mode can be selected.
In­Expert­Mode,­the­rotation­speed­can­
be­set­as­a­percentage.
Levels 1, 2 and 3 of the scale
light­up­with­this­setting­in­Expert­Mode.
-­ The­Tool Total Runtime can be read out
-­ The­frequency­of­the­overtemperature­
times can be read out via Tool
Overtemperature Times
-­ The­frequency­of­the Tool Overcurrent
Times can be read out
-­ The­frequency­of­the Tool Lock Times can
be read out
-­ A­red­dot­next­to­the Firmware Version
indicates­if­an­update­is­available.­The­
update­can­be­installed­by­tapping­the­
firmware­version
-­ You­can­restore­the­operating­settings­
via­the­"Reset"­selection­under­Reset to
Factory Settings. All stored data will be
deleted.
on the control element (6)