Parkside Performance PPHSA 40-Li B2 Traduction Des Instructions D'origine page 34

GB MT
2. To insert the battery (15) into the de-
vice,­push­the­battery­along­the­guides­
into the device. You will hear it click
into­place.
Checking the charge level of
the battery
Press the button for the charge level indica-
tor­(12)­on­the­operational­control­(6)­and­
the charge level indicator (11) signalises
the charge state of the batteries (15) by
illuminating­the­corresponding­LED­lights.
3 LEDs are lit
(red, orange and green): Battery charged
2 LEDs are lit (red and orange):
Battery­partially­charged
1 LED illuminated (red):
Battery needs to be charged
Switching on and off
The cordless hedge trimmer may
only be used with two batteries of
the (Parkside) X 20 V Team series.
­ Ensure­your­stance­is­stable­and­
hold­the­appliance­tightly­with­both­
hands and away from your body.
Before switching the device on,
make sure that it is not touching any
objects.
Removing the blade guard:
1. Pull the blade guard (
safety cutter bar (2).
Switching on:
2.­ Make­sure­that­the­batteries­(15)­are­
inserted­(see­"Removing/inserting­the­
battery").
3. Press the security switch (17) on the
front­handgrip­(4).
34
4. Press the on/off switch (7). The device
5. Release the security switch (17) or on/
After switching on, the device runs at the
lowest­speed.­You­can­read­off­the­current­
speed­from­the­light­on­the­scale­
the­operational­control­(6).
1. Press the button for setting the cutting
Speed­(rpm)
Attaching/removing the clip-
pings collector
1.­ First­slide­the­clippings­collector­(10)­
1.­ Pull­the­clippings­collector­(10)­for-
Working with the device
9) off the
•­ If­the­blades­become­jammed­with­solid­
runs­at­the­lowest­speed.­
For­setting­the­speed,­refer­to­the­sec-
tion­"Setting­the­stroke­rate".
Switching off:
off switch (7).
Setting the stroke rate
speed­(13)­to­set­the­stroke­rate.
Mode
1000 1500 1800
Attaching the clippings collector
with the angled edge onto the safety
cutter bar (2).
Removing the clippings collector
wards off the safety cutter bar (2).
While cutting, make sure that you do
not­touch­any­objects,­such­as­wire­
fences­or­plant­supports.­This­can­
cause damage to the safety cutter bar.
objects,­switch­the­device­off­immedi-
ately and remove the batteries. Only
then­should­you­remove­the­object.
1 2 3
on