Parkside Performance PPHSA 40-Li B2 Traduction Des Instructions D'origine page 31

maintained­power­tools.­
f) Keep cutting tools sharp and
clean. Properly­maintained­cutting­
tools­with­sharp­cutting­edges­are­less­
Iikely­to­bind­and­are­easier­to­control.­
g) Use the power tool, accessories
and tool bits etc. in accordance
with these instructions, taking
into account the working condi-
tions and the work to be per-
formed.­Use­of­the­power­tool­for­op-
erations different from those intended
could result in a hazardous situation.
h) Keep handles and grip surfaces
dry, clean and free from oil and
grease. Slippery­handles­and­grip­
surfaces­do­not­permit­safe­operation­
and­control­over­the­power­tool­in­un-
expected­situations.
5) CAREFUL HANDLING AND USE
OF BATTERY DEVICES
a) Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk­of­fire­if­
a­charger­that­is­suitable­for­a­specific­
type­of­battery­is­used­with­other­bat-
teries.
b) In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result­in­injuries­and­risk­of­fire.
c) Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts
may­cause­burns­or­fire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water.­If­the­liquid­gets­into­eyes,­seek­
medical­assistance.­Leaking­battery­fluid­
may cause skin irritations or burns.
e) Do not use damaged or altered
batteries. Damaged or altered batter-
ies­can­be­unpredictable­and­lead­to­
fire,­explosion­or­risk­of­injury.
f) Do not expose batteries to fire
or elevated temperatures. Fire or
temperatures­over­130 °C­can­cause­
an­explosion.
g) Follow all instructions for charg-
ing and never charge the bat-
tery or the battery-powered tool
outside the temperature range
stated in the operating instruc-
tions. Incorrect­charging­or­charging­
outside­the­permitted­temperature­
range may destroy the battery and in-
crease­the­risk­of­fire.
6) SERVICE
a) Have your power tool serviced
by a qualified repair person us-
ing only identical replacement
parts. This will ensure that the safety
of­the­power­tool­is­maintained.
b) Never repair damaged batter-
ies. All­battery­repairs­should­be­car-
ried out by the manufacturer or author-
ised customer service centres only.
Attention! Observe the de-
tailed safety information and
notes on charging and proper
use as shown in the instruction
manual for your battery and
charger from the (Parkside)
X 20 V Team series. A detailed
description of the charging
process and further informa-
tion can be found in the sepa-
rate operating instructions.
GB MT
31