Makita FS2300X Manuel D'instructions page 4

ENGLISH (Original instructions)
1. Lock ring
2. Locking sleeve
3. Locator
4. Switch trigger
5. Lock button
SPECIFICATIONS
Model
Capacities
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing program of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for screw driving in wood, metal and
plastic.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
SCREWDRIVER SAFETY
WARNINGS
1. Hold power tool by insulated gripping surfaces,
when performing an operation where the fastener
may contact hidden wiring or its own cord.
Fasteners contacting a "live" wire may make exposed
metal parts of the power tool "live" and could give the
operator an electric shock.
2. Always be sure you have a firm footing.Be sure no
one is below when using the tool in high locations.
3. Hold the tool firmly.
4. Keep hands away from rotating parts.
5. Do not touch the bit or the workpiece immediately
after operation; they may be extremely hot and
could burn your skin.
4
Explanation of general view
6. Lamp
7. Reversing switch lever
8. Hook
9. Gear housing
10. Bit
Self drilling screw
Drywall screw
-1
)
ENE033-1
ENF002-2
GEA010-1
GEB017-4
FS2200
6 mm
5 mm
0 - 2,500
287 mm
1.6 kg
SAVE THESE INSTRUCTIONS.
WARNING:
DO NOT let comfort or familiarity with product (gained
from repeated use) replace strict adherence to safety
rules for the subject product.
MISUSE or failure to follow the safety rules stated in
this instruction manual may cause serious personal
injury.
FUNCTIONAL DESCRIPTION
CAUTION:
• Always be sure that the tool is switched off and
unplugged before adjusting or checking function on the
tool.
Depth adjustment
For Model FS2200, FS2300 (Fig. 1)
The depth can be adjusted by turning the lock ring. Turn it
in "B" direction for less depth and in "A" direction for more
depth. One full turn of the lock ring equals 2.0 mm change
in depth.
For Model FS2300X (Fig. 2)
The depth can be adjusted by turning the locking sleeve.
Turn it in "A" direction for less depth and in "B" direction
for more depth. One full turn of the locking sleeve equals
1.5 mm change in depth.
For all Models
Adjust the lock ring so that the distance between the tip of
the locator and the screw head is approximately 1 mm as
shown in the figures. Drive a trial screw into your material
or a piece of duplicate material. If the depth is still not
suitable for the screw, continue adjusting until you obtain
the proper depth setting. (Fig. 3 & 4)
11. Magnetic bit holder
12. Swells
13. Trapezoidal holes
14. Locator holder
FS2300
6 mm
5 mm
0 - 2,500
290 mm
1.6 kg
/II
FS2300X
6 mm
5 mm
0 - 2,500
305 mm
1.6 kg