Festool SYSLITE KAL II Guide D'utilisation page 7

6.4 Temperature monitoring
If the device temperature does not re-
main within the specified limits, the
working light switches to emergency
mode. It reduces luminosity and then
switches off after 2 minutes.
6.5 Power failure mode
The working light has a power failure
mode. It automatically lights up the work
area in the event of a sudden power fail-
ure.

Hold down the ON/OFF switch [1-2]
and insert the mains charging adapter
or car charging adapter in the connec-
tor socket [1-4].
The working light turns off and the
charging indicator switches to flashing
orange (charging) or continuous orange
(fully charged). depending on the operat-
ing state.
In the event of an interruption to the ex-
ternal voltage supply, the working light
automatically switches on.
Switching off the mode:

Press the ON/OFF switch [1-2] again.
Charging indicator switches to standard
mode, see
chapter 6.1
.
6.6 Operating with external Festool
battery pack [3A] + [3B]
Inserting battery pack
1
3A
The working light can operate with any
Festool battery pack from the BPC or
BPS series. When connected to the ex-
ternal Festool battery pack, the working
light only consumes power from this bat-
tery pack.
2
7