Publicité
Les langues disponibles
Les langues disponibles
AIR STAPLER & NAILER
PDT 40 F4
z Introduction
Congratulations on the purchase of your new
device. By doing this you have chosen one
of our high-quality products. The operating
instructions form part of this product. They
contain important information on safety,
usage and disposal. Please familiarise your-
self with all operating and safety instructions
before using the product. Use the product
only as described and only for the specific
applications as stated. Ensure you hand over
all documentation when passing the product
on to anyone else.
z Intended use
The air stapler is designed for installation
and repair work. You must wear the appro-
priate eye protection every time you use it.
Caution! This device may
be used only as specified
herein.
Use on hard materials such as stone, metal,
etc. is not permitted.
Keep these instructions in a safe place.
Ensure you hand over all documentation
when passing the product on to anyone else.
Any use that differs to the intended use as
stated above is prohibited and potentially
dangerous. Damage or injury caused by
misuse or disregarding the above warning
is not covered by the warranty or any
liability on the part of the manufacturer. This
product is not suitable for commercial use.
It is only suitable for domestic use or similar
applications. Commercial use will void the
guarantee.
Only trained persons may
start up this product.
Keep out of the reach of
children!
NOTE:
The use of the term 'product' or 'device' in
the following text refers to the air stapler &
nailer named in these operating instructions.
z Package contents
Air Stapler & Nailer
1
PDT 40 F4
1
Carry case
Oil container with
1
compressed air special oil
Threaded barbed fitting,
1
6.35 mm (¼")
(pre-assembled)
Pack of nails, 1000 pcs.
1
(15 mm, 25 mm, 40 mm,
50 mm, pack of 250)
Pack of staples, 1000 pcs.
(16 mm, 40 mm,
1
pack of 250 and 25 mm,
pack of 500)
1
Protective goggles
1
Operating instructions
z Equipment
1
Exhaust air outlet (can be rotated)
2
Trigger
3
Handle
4
Threaded barbed fitting 6.35 mm (¼")
5
Cover cap
6
Magazine lever
7
Magazine
GB/IE/NI/CY/MT
7
Publicité
