Publicité
Les langues disponibles
Les langues disponibles
z Maintenance by the user
Lubricate with the oil-atomiser:
NOTE: As a preparatory step, after the
pressure reducer an oil-atomiser lubricates
the air stapler continuously and in the very
best way. An oil-atomiser dispenses oil in
fine droplets into the airflow and thereby
guarantees regular lubrication.
Fit the oil-atomiser after the (filter) pres-
„
sure reducer. To do this, plug the barbed
fitting of the oil-atomiser into the quick
coupler of the (filter) pressure reducer.
Then connect the compressed air device
„
to the quick coupler provided for this
purpose.
Manual lubrication:
NOTE: If you do not have an oil-atomiser,
you must lubricate after you have used
approximately 5000 fasteners.
Put 1–2 drops of compressed air special
„
oil into the threaded barbed fitting
the air stapler.
Then press the trigger
„
ATTENTION: Under no circumstances
should you use too much oil, as otherwise
this could leave the mouth with the fastener
and this could possibly damage the work-
piece.
z Cleaning
Do not use sharp objects to clean the
„
device and the protective goggles.
Do not allow liquids to get inside the
unit – Otherwise, the device could be
damaged.
Clean the device and protective goggles
„
regularly. The best time to do so is
straight after completing work.
Clean the device housing with a dry
„
cloth.
4
of
2
a few times.
Clean the protective goggles with a soft
and dry or moistened cloth or clean it
with a cloth moistened with disinfectant –
under no circumstances should you use
gasoline, solvents or cleaners which
corrode plastic.
After every use, pack the air stapler, pro-
„
tective goggles and the compressed air
special oil into the carry case delivered
with the product, in order to protect it
from contamination.
NOTE: Using, cleaning and storing the
protective goggles can reduce the service
life of approx. 3 years. If the viewing pane
is scratched or there is other visible damage
on the protective goggles, replace them
immediately.
z Information about recycling
and disposal
Do not dispose of the product
including accessories in standard
household waste, take it to your
municipal collection points for
material recovery.
The packaging is made of environ-
mentally-friendly material, which
you can dispose of at your local
recycling centres.
Note the labelling on the packag-
ing and separate the packaging
material components for disposal if
necessary. The packaging material
is labelled with abbreviations
(a) and numbers (b) with the following
meanings: 1–7: Plastics, 20–22: Paper and
cardboard, 80–98: Composites.
GB/IE/NI/CY/MT
23
Publicité
