Publicité
Les langues disponibles
Les langues disponibles
11
the mouth
touches the workpiece.
The fastener leaves the device.
As long as you keep the trigger
„
pressed, then, every time the mouth
touches the workpiece, then a fastener
will leave the device.
Alternatively you can also keep the
„
11
mouth
of the device pressed continu-
ously onto the workpiece.
Every time you press the trigger
„
fastener leaves the device.
In all cases you should endeavour to work
with the lowest level of air pressure. This
brings you three significant advantages:
1) You save energy,
2) You reduce the noise level,
3) You reduce the wear on the fastening
device.
Avoid triggering the fastening device when
the magazine is empty. If the fastening
device is defective or is not working
properly, disconnect it immediately from
the compressed air and hand it over to
an expert for inspection. During long
work breaks or when work has finished,
disconnect the device from the compressed
air system and ideally empty the magazine.
Protect the compressed air connections of
the fastening device and the hose lines
against contamination. Penetration of
coarse dust, chips, sand, etc. leads to leaks
and damage to the fastening device and
couplings.
NOTE: It is also possible to carry out
fine-tuning using the knurled screw
Rotate the knurled screw
„
make the fastener go deeper into the
workpiece.
Rotate the knurled screw
„
the fastener go less deep into the
workpiece.
22
GB/IE/NI/CY/MT
„
2
11
„
z Removing jammed staples
2
one
„
„
„
„
„
z Maintenance
Always disconnect the
device from the compressed
air supply and empty the
magazine before cleaning
and/or carrying out main-
tenance work.
9
.
9
down, to
9
up, to make
Rotate the exhaust air outlet
the exhaust air flow point in the direction
you want.
Disconnect the device from the compres-
sor after completing work.
If a staple/nail has got stuck in the
magazine shaft, remove the compressed
air supply immediately.
Open the magazine
the "Load magazine" chapter.
Open the face plate
quick clamp lever for the face plate
in the direction of the trigger safety
10
catch
.
Remove the jammed fastener. Close the
12
face plate
by pulling the quick clamp
lever for the face plate
of the exhaust air outlet
Close the magazine
as described in the "Load magazine"
chapter.
DANGER OF INJURY!
1
, to guide
7
as described in
12
by pulling the
13
13
in the direction
1
.
7
of the air stapler,
Publicité
