Hikmicro HM-TD3028T-2/Q Guide De Démarrage Rapide page 8

12
Power Supply
Interface
13
Serial Port
14
Alarm Interface
15
RS-485 Interface For RS-485 communication.
16
CVBS Interface
17
Network
Interface
3. Install Camera (Page 2 – B)
Before installation, make sure that the installation surface is strong
enough to withstand four times the weight of the device and the
accessory. Check the specification of the products for the
installation environment.
Select a desired installation method from B.1 to B.4.
Installation Method and Steps
Method Steps
Attach the device to a ferromagnetic surface.
B.1
1. Paste the drill template to the installation surface.
B.2
2. Drill 4 screw holes (Ø 3 mm, 0.12 inch) at the
position marked with "2" on drill template.
3. Fix the device to the surface with 4 supplied M3×10
screws.
1. Paste the drill template to the installation surface.
B.3
2. Drill 4 screw holes (Ø 3.5 mm, 0.14 inch) at the
position marked with "1" on drill template.
3. Fix the device to the surface with 4 supplied M3×15
screws and M3 nuts.
Purchase a PT joint in advance.
B.4
1. Disassemble the PT joint.
2. Install the PT joint base to installation surface, and
then install the PT joint bracket back.
12 VDC input.
For debugging only.
Alarm input and output.
*Alarm input interface varies according
to different camera models, please refer
to the actual product.
For debugging only.
RJ45 network interface, 100 Mbps,
shielded cable.
6