OHAUS Frontier FC5917RF Manuel D'instructions page 20

TM
Frontier Centrifuges
See "table 5: acceleration and deceleration times" (APPENDIX). There the acceleration and deceleration times
for the acceleration and deceleration stages 0 to 9 for permissible rotors are shown.
M7
A-2
5
3.3.4 Pre-selection of temperature (Only Refrigerated Models)
This function is activated by the key "Temp/Setup" (13). After pressing this key in the display "Time/Prog" the
indication "°C " (A-4) flashes. By the adjusting knob (1) the desired test temperature can be pre-selected in steps of
1°C in a range from -20°C up to +40°C.
The value is indicated permanently in the display (figure 22) - before, during and after the run.
Please notice the respective lowest temperatures of the rotors at maximum speed!
13
M8
Figure. 21
A-4
Figure. 22
EN-11
1
1