Publicité
Les langues disponibles
Les langues disponibles
Start-up
• Place the magnet in the bracket at
the back side and place the back
side into the housing of the mag-
netic contact.
1
Figure 8
When using the spacer (E), fasten
the smaller adhesive strip at the
back side of the spacer
figure)
and attach it to the desired
position on the window. After-
wards, place the magnet contact
on to the spacer.
• Attach the small double-sided ad-
hesive strip to the back side of the
magnet contact (D)
and press the magnet contact onto
the desired position of the window.
Make sure that the mounting sur-
face is smooth, solid, non-dis-
turbed, free of dust, grease and
solvents and not too cold to en-
sure long-time adherence.
Screw mounting
Using screws will damage the
window and/or door. For those
living in rented accommodation,
this could lead to a landlord mak-
ing claim for compensation or
holding back a tenant's deposit.
2
(see
(see figure)
Do not yet assemble the magnet
contact before screw mounting.
For mounting the window / door con-
tact with the supplied screws, please
proceed as follows:
• Pre-drill the screw holes in the
bracket (A) using an appropriate
drill.
• Mark the screw holes for the elec-
tronic unit (B) on the window with
the aid of the bracket (A).
• Mark the screw holes for the mag-
net contact (D) or, if required, for
the spacer (E) on the window.
1
Figure 9
• If you are working with hard sur-
faces you should pre-drill the holes
marked using a 1.5 mm drill (not
necessary for soft surfaces).
2
2x
24
Publicité
