HomeMatic IP HmIP-SWDM-2 Notice D'installation Et D'emploi page 20

Start-up
6 Start-up
6.1 Pairing
Please read this entire section
before starting the pairing proce-
dure.
You can pair the device either directly
to a Homematic IP Radiator Thermo-
stat – basic or to the Homematic IP
Access Point (HmIP-HAP). After pairing,
configuration has to be done directly
on the device. After pairing with the
Access Point, configuration is done via
the Homematic IP app.
6.1.1 Direct pairing with a
Homematic IP device
You can pair Homematic IP win-
dow and door contacts with mag-
net to a Homematic IP Radiator
Thermostat – basic (HmIP-eTRV-B
/ HmIP-eTRV-B-2).
Please make sure you maintain a
distance of at least 50 cm be-
tween the devices during pairing.
You can cancel the pairing proce-
dure by briefly pressing the sys-
tem button (C) again. This will be
indicated by the device LED (C)
lighting up red.
To connect the device with anoth-
er Homematic IP device, the pairing
mode of both devices must be ena-
bled. To do this, proceed as follows:
• Remove the electronics unit (B)
from the holder (A)by sliding it up-
wards and removing it forwards.
Figure 2
• Remove the insulation strip from
the battery compartment (F) of the
window / door contact.
• Press and hold the system button
(C) for at least 4 seconds to enable
the pairing mode. The device LED
(C) starts to flash orange. The pair-
ing mode is active for 3 minutes.
• Press and hold down the system
button of the device you want to
connect (e.g. the radiator thermo-
stat – basic) for at least 4 seconds
to activate the pairing mode. The
device LED starts to flash orange.
For further information, please re-
fer to the operating manual of the
corresponding device.
4 s
Figure 3
2
1
20