HomeMatic IP HmIP-SWDM-2 Notice D'installation Et D'emploi page 22

Start-up
• To confirm, enter the last four dig-
its of the device number (SGTIN) in
your app, or scan the QR code. The
device number is on the sticker in
the package contents or attached
to the device.
• Wait until pairing is completed.
• If pairing was successful, the LED
(C) lights up green. The device is
now ready for use.
If the LED lights up red, please try
again.
• Please select, in which application
(e.g. climate control and/or secu-
rity) you would like to use the de-
vice.
• In the app, give the device a name
and allocate it to a room.
6.2 Installation
Please read this entire section
before starting the installation.
6.2.1 Selecting a suitable mounting
location
• Select a window or door for
mounting the window / door con-
tact.
• Fix one part of the window / door
contact (magnet contact (D) or
electronic unit (B)) to the moving
part (door or window wing), the
other one at the stationary part
(frame) of the window or door.
Figure 5
• Fasten the window / door contact
on the side of the window or door
where the handle is located, in the
upper third of the window/door
frame( for fastening details, see
(see „6.2.2 Adhesive strip or screw
mounting" on page 23)).
22