HomeMatic IP HmIP-SWDM-2 Notice D'installation Et D'emploi page 23

Start-up
• The magnet contact can be
mounted in a horizontal or vertical
way, left or right to the electronic
unit of the window / door contact.
5 mm
Figure 6
The electronic unit and the mag-
net contact should be mounted at
the same height. As a spacer (E)
can be used for the magnet con-
tact to raise the magnet contact,
the electronic unit must be
mounted on the higher part of the
window.
The ideal spacing between the
housing edge of the window/door
contact and the window/door
casement should be 5 mm
figure).
6.2.2 Adhesive strip or screw
mounting
You can mount the window / door
contact with
• the double-sided adhesive strip or
• countersunk head screws
to the window/door frame.
Do not yet assemble the magnet
contact before screw mounting.
Adhesive strip mounting
For mounting the window / door con-
tact with the supplied adhesive strip,
please proceed as follows:
• Attach the large double-sided
adhesive strip to the back of the
bracket (A) and press the device
into the desired position on the
5 mm
window.
1
3
(see
Figure 7
2
2x
4
23